Leprecon LP-X24 Manual v3.2 - Manual (Page 14)

10 Introduction
LP-X24 and LP-X48 Users Manual
On the LP-X48 (not shown), this section includes 24 Manual Scene Faders, Bump
buttons for each and the Bank switching button.
• Playback Section: Includes the Page selector and display, Playback select buttons,
faders and bumps, and the Programmer fader. The LP-X24 (shown below) has six
playbacks. The LP-X48 (not shown) has twelve playbacks.
Power Up and Down Sequences
When the LP-X arrives from the factory, it will be set to operate on 110V current. To
change the setting to 220V, move the red switch that is underneath the power jack from
the 115 setting to the 230 setting.
To Power Up the LP-X
1. Move the power switch to the On position.
The power switch is located on the back of the console next to the power cord jack.
The LP-X starts in Run/Scene mode and displays the Conventional Channels
screen.
LP-X24