Leprecon LP-X24 Manual v3.2 - Manual (Page 22)

18 Introduction
LP-X24 and LP-X48 Users Manual
For example, the LP-X24 has one set of faders in the Manual Scene section of the
console, but pressing the Bank button changes the faders from numbers 1 through
12 to numbers 13 through 24. Assume that you set fader 1 to a level of 50%. You
then press the Bank button so that you are controlling faders 13 through 24. You set
fader 13 to a level of 100%. You press the Bank button again, giving you control of
faders 1 through 12 again. Fader 1 was set to a level of 50% but the fader position is
at 100% because it was used to set the level for fader 13. You must move the fader
to the 50% position (matching) before you can change the level (grabbing) for fader
1.
• The Filter (Moving Light/Dimmer/Both) setting determines what information is saved
when you:
(1) press a Playback Select button,
(2) press the Stack Select button,
(3) press the Save softkey on the Conventional Programmer screen or the ML
Programmer screen,
(4) press the Save As softkey on the ML Programmer screen.
When the filter is set to Moving Light, only moving light information is saved. When
the filter is set to Dimmer, only conventional light information is saved. When the
filter is set to Both, information for moving lights and conventional lights is saved. In
the manual, we always show the minimum filter setting that must be used to
complete an operation
you may always set the filter to Both.
• On the Moving Light Programmer screen, pressing the Color softkey once
displays color labels. The softkey button text changes from "Color" to "ColrFx".
Pressing it a second time displays the Color Effects screen.
• On the Moving Light Programmer screen, pressing the Beam softkey once
displays beam labels. The softkey button text changes from "Beam" to "BeamFx".
Pressing it a second time displays the Beam Effects screen.
• On the Moving Light Programmer screen, pressing the Focus softkey once
displays focus labels. The softkey button text changes from "Focus" to "FocsFx".
Pressing it a second time displays the Focus Effects screen.
Using the Keypad
• When you use the keypad to enter a name, the first press of a letter key enters the
first letter on the key. The second press of the same key changes the entry to the
second letter on the key. The third press of the same key changes the entry to the
third letter on the key. The fourth press of the same key changes the entry to the
number of the key. The fifth press of the same key changes the entry to the first
letter on the key
the same result as the first key press. If you wait more than 1.25
seconds between presses, the LP-X assumes that you have entered what you want
and advances to the next square.