Marantz AV7702 Owner Manual - Manual (Page 180)

Audyssey
Set Audyssey MultEQ ® XT32, Audyssey Dynamic EQ ® , Audyssey
Dynamic Volume ® and Audyssey LFC™. These can be selected after
Audyssey ® Setup has been performed.
For additional information on Audyssey technology, please see
“Explanation of terms” (v p. 304).
0 “MultEQ ® XT32”, “Dynamic EQ”, “Reference Level Offset”, “Dynamic Volume”,
“Audyssey LFC™”, “Containment Amount” and “Audyssey DSX ® ” settings are
stored for each input source.
0 When the sound mode is in the “Direct” or “Pure Direct” mode, “MultEQ ® XT32”,
“Dynamic EQ” and “Dynamic Volume” settings cannot be configured.
0 This cannot be set when the input mode is set to “7.1CH IN”.
o MultEQ ® XT32
MultEQ ® XT32 compensates for both time and frequency
characteristics of the listening area based on Audyssey ® Setup
measurement results. Selection is done from three types of
compensation curves. It is recommended that “Reference” is selected.
Reference
(Default):
Selects the default calibrated setting with
a slight roll off at high frequencies, which
is optimized for movies.
L/R Bypass:
Selects the reference setting, but
bypasses MultEQ
® XT32 on the front left
and right speakers.
Flat:
Selects the calibrated setting which is
optimized for small rooms where your
listening position is closer to the
speakers.
Off : Turn “MultEQ ® XT32” equalizer off.
When the headphones are used, “MultEQ ® XT32” is automatically set to “Off”.
Contents Connections Playback Settings Tips Appendix
180 Front panel Display Rear panel Remote Index