Marantz AV7702 Owner Manual - Manual (Page 284)

o Cannot connect to a wireless LAN network
Symptom Cause / Solution Page
Cannot connect to the
network.
0
The network name (SSID), password and encryption setting have not been set up correctly. Configure the
network settings according to the setting details of this unit.
237
0
Shorten the distance from the wireless LAN access point and remove any obstructions to improve access
first before re-connecting again. Place the unit away from microwave ovens and other network access
points.
－
0
Configure the access point channel settings away from channels that are being used by other networks. －
0
This unit is not compatible with WEP (TSN). －
Cannot connect to WPS.
0
Check that the WPS mode of the router is operating. －
0
Press the WPS button on the router and then press the “Connect” button displayed on the TV within 2
minutes.
－
0
A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption time to
“None”, “WPA-PSK (AES)” or WPA2-PSK (AES).
237
0
If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by using the WPS
button. In this case, use the “Scan Networks” or “Manual” method to connect.
－
Cannot connect to the
network using iPhone/iPod
touch/iPad.
0
Update the iPhone/iPod touch/iPad firmware to the latest version. －
0
When using a USB cable to configure the settings, the iOS device firmware version needs to support iOS
5 or later. When configuring the settings via a wireless connection, iOS 7 or later needs to be supported.
－
Contents Connections Playback Settings Tips Appendix
284 Front panel Display Rear panel Remote Index