Marantz AV7702 Owner Manual User Manual

Page 273

Advertising
background image

Symptom

Cause / Solution

Page

DTS Neo:X mode cannot

be selected.

0

It cannot be selected when “Speaker Config.” - “Surround” is set for “None”.

224

0

DTS Neo:X cannot be selected when using the headphones.

Dolby Surround mode

cannot be selected.

0

Dolby Surround cannot be selected when using the headphones.

Audyssey MultEQ

®

XT32,

Audyssey Dynamic EQ

®

,

Audyssey Dynamic
Volume

®

and Audyssey

LFC™ cannot be selected.

0

These cannot be selected when you have not performed Audyssey

®

Setup.

203

0

Switch to a sound mode other than “Direct” or “Pure Direct”.

139

0

These cannot be selected when using the headphones.

Audyssey DSX

®

cannot be

selected.

0

It can be selected when using the front height or front wide speakers.

225

0

It can be selected when using the center speaker.

224

0

Switch the sound mode to Dolby sound mode or DTS sound mode.

138

0

This cannot be selected when using the headphones.

0

This cannot be set when the input signal is a 2-channel source.

“M-DAX” cannot be

selected.

0

Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of

multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.

178

0

Switch to a sound mode other than “Direct” or “Pure Direct”.

139

No audio is output from

PRE OUT or speakers for

ZONE2/ZONE3.

0

In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/

COAXIAL) are in 2ch PCM format.

0

In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM

format. To play back the audio in ZONE2 irrespective of the input signal format, set “HDMI Audio” in the

menu to “PCM”. Depending on the played back device, the audio may not be played back even with this

setting. In that case, set the audio format to “PCM (2ch)” on the played back device.

243

0

When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the

Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.

Contents

Connections

Playback

Settings

Tips

Appendix

273

Front panel

Display

Rear panel

Remote

Index

Advertising
This manual is related to the following products: