V p. 204), O about the main listening position, O about audyssey sub eq ht – Marantz AV7702 Owner Manual User Manual

Page 204

Advertising
background image

o About the main listening position

The main listening position is the position where listeners would

normally sit or where one would normally sit alone within the listening
environment. Before starting Audyssey

®

Setup, place the Sound

calibration microphone in the main listening position.
Audyssey MultEQ

®

XT32 uses the measurements from this position to

calculate speaker distance, level, polarity, and the optimum crossover

value for the subwoofer.

o About Audyssey Sub EQ HT™

Audyssey Sub EQ HT™ makes the integration of dual subwoofers

seamless by first compensating for any level and delay differences
between the two subwoofers and then applying Audyssey MultEQ

®

XT32 to both subwoofers together.
To run Audyssey Sub EQ HT™ you must select “Measure (2 spkrs)” in

“Channel Select”. (v p. 206).

NOTE

0 Make the room as quiet as possible. Background noise can disrupt the room

measurements. Close windows and turn off the power on electronic devices

(radios, air conditioners, fluorescent lights, etc.). The measurements could be

affected by the sounds emitted by such devices.

0 During the measurement process, place cell phones outside the listening room.

Cell phone signals could disrupt the measurements.

0 Do not stand between the speakers and Sound calibration microphone or allow

obstacles in the path while the measurements are being made. Also, install the

Sound calibration microphone at least 20 inches (50 cm) away from the wall.

Failure to do so will result in inaccurate readings.

0 During the measurement process, audible test tones will come from the speakers

and subwoofer(s), but this is part of normal operation. If there is background noise

in the room, these test signals will increase in volume.

0

Operating VOLUME d f on the remote control unit or VOLUME on the main unit

during the measurements will cancel the measurements.

0 Measurement cannot be performed when headphones are connected. Unplug the

headphones before performing Audyssey

®

Setup.

Contents

Connections

Playback

Settings

Tips

Appendix

204

Front panel

Display

Rear panel

Remote

Index

Advertising
This manual is related to the following products: