NavCom SurveCE Integration Rev.A - Manual (Page 144)

SurvCE™ Integration User Guide – Rev. A
B-142
Create New Project for Rover
1. Create a new project for the rover.
2. Connect to the rover. Define the coordinate
system. Initiate GPS raw data logging (see steps
in Use Local Coordinates from Appendix A,
section From Known Position Tab), then complete
the radio configuration. Tap
.

The receiver should be in RTK Fixed
mode.
3. Tap the Job menu to view the rover *.crd job (e.g.,
rover1.crd).
4. Tap GPS Rover to start the Bluetooth bonding, if
using Bluetooth.
5. Select Internal UHF radio.
6. Tap the RTK tab or to start transmitting
corrections.
7. Format the SD card.
8. Select the rover *.crd file from the Files on the
Receiver window.
Shoot Points
1. Tap the Store Points menu.
2. Tap S from the Store Points table (see Figure 55).
3. Tap . The data logging starts.
4. Tap Close the File to stop data logging.
Collect Points
The system is now ready to collect points.