NavCom SurveCE Integration Rev.A - Manual (Page 61)

SurvCE ™ Integration User Guide – Rev. A
3-59
Figure 28: Configure Internal UHF Radio Window
Refer to Figure 28 for the settings below:
6. Set the power and channel (frequency) options for
the base radio modem as needed.
• The RF power output options are 10mW to
1W. The 1 watt setting provides the maximum
range and causes the maximum discharge on
the battery. Select a lower setting for surveys
over small areas.

Frequency, channel spacing, and
Network ID settings must match in both
the base and receiver.

The ID isolates the base and rover radio
modems. It avoids cross-talk between
the rover radio modem and any other
base radio modems in the area that may
be set to the same frequency.