NavCom SurveCE Integration Rev.A - Manual (Page 35)

SurvCE ™ Integration User Guide – Rev. A
3-33
Before accessing the SurvCE interface, verify the
correct interfaces (physical connections) between the
base and rover receivers and the handheld data
collector.
Figure 6 : Serial Cable
1. For this initial operation of the LAND-PAK,
connect the selected controller, e.g., Nautiz X7 or
preferred data collector to COM 2 of the base
station GNSS sensor. Use the supplied 6 ft. serial
cable (see Figure 6).

If wireless connectivity is preferred,
configure the Bluetooth option for the
base. Refer to the section GPS Base
Setup.

Refer to the supplied Carlson SurvCE
manual for additional information.