NavCom LAND-PAK Rev.E - Manual (Page 114)

LAND-PAK
™ User Guide – Rev. E
A-112
b. Press the up or down arrow soft key to
change the value of the digit, if needed.
c. Repeat steps a and b, above, for each
configurable digit.
When the cursor is at the last configurable
digit, the Set option appears in the bottom
right of the LCD display (see Figure 68).
Figure 68: Set Frequency
d. Change the value of the last configurable digit,
if needed.
e. Press the Set soft key to set the frequency
changes. Or, press the Cancel soft key to
cancel the changes.

If the frequency is set within the
acceptable range, a confirmation message
is displayed temporarily. Then the main
menu returns.

If the frequency is set outside the
acceptable range, an error message is
displayed temporarily. Then the main
menu returns. No change is made to the
center frequency. Repeat the RF
frequency configuration procedure to
change the frequency.

If the frequency changes are canceled, the
display returns to the main menu.
4. Continue to the next section, to configure the RF
power output.