NavCom LAND-PAK Rev.E - Manual (Page 64)

LAND-PAK
™ User Guide – Rev. E
4-62
Figure 24: Mounting the MicroSurvey Nautiz X7
Refer to Figure 24 for the steps below:
3. Connect the clamp assembly to the rover pole:
a. Loosen the knob on the pole clamp.
b. Connect the pole clamp to the rover pole above
the level so that it does not obscure the level from
view.
c. Tighten the knob.
4. Mount the Nautiz X7 on the cradle clamp and
tighten the cradle knob.
Do not over-tighten the cradle. Over
tightening may cause damage to the
Nautiz X7 screen.
Do not lean the pole in a location
where the equipment is likely to fall.
Though the electronic products are
tested for a pole drop, repeated drops
or drops on the wrong axis may still
cause equipment damage.
5. Extend the rover pole to the maximum height
possible and snap it into place. This may require