NavCom LAND-PAK Rev.E - Manual (Page 117)

LAND-PAK
™ User Guide – Rev. E
A-115
3. Press the down arrow soft key to move the cursor
down the main menu to Sig. Threshold.
4. Press the Change soft key to change the Signal
Threshold level. A submenu is displayed with
available negative dBm settings. Set the threshold
to -116dBm.
5. Press the Set soft key to set the threshold level.
The display returns to the submenu with the
cursor at TX level.
6. Press the Back soft key to return to the main
menu.
Addressing Settings
The Addressing factory default is set to Off. The TX
addr must be ON and the address ID must match the
rover setting. The rover requires a network ID in the
SF-3040 (other than 0).
Figure 74: Network Address
1. Press the Change soft key to change the TX
Address. A submenu is displayed with available
settings. Set the TX addr to ON.
2. On the first row of 4-digit values, set the network
ID of the UHF radio. The rover network ID must
match this value, otherwise RTK corrections will
not be received by the SF-3040.
3. Press the Set soft key to set the addressing. The
display returns to the submenu with the cursor at
RX addr Off.