NavCom LAND-PAK Rev.E - Manual (Page 80)

LAND-PAK
™ User Guide – Rev. E
5-78
2. On the Instrument Selection dialog box (refer to
Figure 40), select GNSS Rover.
3. Click Connect to connect to the SF-3040
receiver.

If the SF-3040 is not already in the
Instrument Profile list, add it to the list
first then edit the settings. The Rover
and Reference are handled separately.
4. On the Link Configure dialog box (refer to Figure
41), select StarFire. This sets the positioning
mode to StarFire.
5. Click Connect.
6. From the map display, click .
7. On the Instrument Settings dialog box (refer to
Figure 43), click StarFire QuickStart.

If StarFire QuickStart Reset or StarFire
Reset Cancel are displayed, cancel the
Quick Start and reinitiate StarFire
QuickStart.