NavCom LAND-PAK Rev.E - Manual (Page 95)

LAND-PAK
™ User Guide – Rev. E
5-93
StarFire Tolerance
Perform these steps to set the StarFire tolerance
parameters:
1. Open FieldGenius and select a project or create a
new one.
2. On the Instrument Selection dialog (refer to
Figure 40), select GNSS Rover.
3. Click Edit.
4. On the GNSS Profile dialog box (refer to Figure
28), select Tolerance Setting [StarFire].
5. On the Tolerance 1 dialog box (refer to Figure
55), set the parameters and click OK.

The recommended setting is:
Position (H): 10cm
Position (V): 15cm
When setting the above parameters,
keep the selection StarFire Dual on
the Solution drop-down list box.