Quintum Technologies Tenor AS - Manual (Page 122)

FCC WARNINGS
This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interface will not occur in a particular installations. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 68 of the FCC Rules and the requirements adopted by ACTA. On the back of
this equipment is a label that contains, among their information, a product identifier in the format
US:6LCPF01AAS-SERIES. If requested, this information must be provided by the Telephone Company.
The REN (Ringer Equivalence Number) is used to determine the number of devices that may be connected to
a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an
incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as determined by the total RENs, contact the local tele-
phone company. For products approved after July 23, 2001, the REN for this product is part of the product
identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a dec-
imal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.
Facility Interface Codes For Analog Services supported:
• 02LS2
Service Order Codes For Analog Services supported:
• 9.0F Full protection to the network from systems using live voice. Only approved terminal equipment
can be connected to station ports
An FCC compliant telephone cord with a modular plug is provided with this equipment. This device connects
to the telephone network via an RJ-11 plug and jack. The plug and jack also comply with FCC part 68 rules.
If this device causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But, if advance notice is not practical, the Telephone
Company will notify the customer as soon as possible. Also, you will be advised of your right to file a com-
plaint with the FCC if you believe it is necessary.
The Telephone Company may make changes in its facilities, equipment, operations, or procedures that could
effect the operation of the equipment. If this happens, the Telephone Company will provide advance notice in
order for you to make necessary modifications to maintain uninterrupted service.