Quintum Technologies Tenor AS - Manual (Page 39)

P/N 480-0059-00-10 3-3
Chapter 3: Installation/Basic Troubleshooting
Connect to Phone/FXS Interface
Since there are many different PBX devices, keys systems, fax machines and phones you can con-
nect to the Tenor AS, the instructions which follow explain the general procedure for connecting an
RJ-11 cable (included in your package) between the Phone/FXS port and an external device. Use the
phone/FXS ports for on-premise wiring only.
For the ASM200 and ASG200, you can connect one device to each FXS port. For the ASM400 and
ASG400, you can connect two devices to each FXS port (using an RJ-11 Dual Port Splitter).
See Chapter 2: Hardware Components for the RJ-11 cable pinouts you can use to acquire another
cable or adaptor that may be required to connect to the specific external device.
Figure 2-1 Connect to Phone/FXO port
Connect to Phone/FXS port as follows:
CAUTION: Connect the Phone/FXS ports to a telephone, fax machine, PBX or key system only.
Connecting to other devices/networks (i.e., telephone wall jack) will cause damage to
the unit.
1. Plug one end of the RJ-11 cable into one of the two ports on the front of the unit labeled Phone/FXS. See
Chapter 2: Hardware Components for cable pinouts.
2. Insert the other end of the RJ-11 cable into the appropriate analog port on the PBX or key system, or into
the jack on the back or underside of the phone or fax machine. For the PBX connection, see your PBX doc-
umentation port requirements for connection specifics.
RJ-11
For ASM400, an RJ-11 Dual Port Splitter
Cable is used in each port enabled for 4 FXS
RJ-11 Dual Port Splitter
PBX
ports.
Phone