Quintum Technologies Tenor AS - Manual (Page 31)

2-8 P/N 480-0059-00-10
Chapter 2: Hardware Components
Cables
The cables listed in Table 2-6 are required to connect a Tenor AS to various interfaces. Contact Quin-
tum for ordering information, if necessary.
Table 2-6 Cables Supported
RJ-11 Cables (for ASM200, ASG200)
An RJ-11 cable is used to connect the Tenor AS to an FXO or FXS external device. The RJ-11 cable
connector pinouts are given in this section to help you identify the proper connector to accommo-
date your specific networking requirements. The RJ-11 connector is the EIA/TIA standard for
Unshielded Twisted Pair (UTP) cable; the wiring color codes are UTP Standard Coloring. The pin
order is shown in Figure 2-6.
Figure 2-6 RJ-11 Pin Order
Cable Usage
RJ-11 to RJ-11 Cable Connection to FXO/Line. (For the AS400 unit.
a Dual Port Splitter Cable is required.)
RJ-11 to RJ-11 Cable Connection to FXS/Phone. (For the AS400
unit, a Dual Port Splitter Cable is required.)
RJ-11 Splitter Cable Connection to ASM400 units enabled for four
FX0 ports or to ASM400 units enabled for
four FXS ports.
RJ-45 Ethernet cable Connection to Ethernet LAN 10/100
DB-9 Serial RS-232 Connection to PC’s asynchronous console
port.
AC power adaptor/cord One AC power adapter/cord for connection to
AC power jack.
4
1
1
4
Top View