Teac HS-4000 - Manual (Page 121)

TASCAM HS-4000
121
12 – Mark and locate functions
Editing mark names
1. Select the mark that you want to edit on the MARK LIST
screen.
2. Touch the EDIT NAME button to open the MARK NAME
screen.
Use the same input method as in “Editing the project name”
on page 40.
If you want to input a BWF-J cue name, touch the BC$button
at the upper right and select a cue name from the pull-down
menu that appears.
NOTE
You can also open the MARK NAME screen by touching the
mark name area on the Home Screen (in timeline mode,
when the INFO display is open).
However, since the names of automatic marks cannot be
edited, the MARK NAME screen is not shown for them.
Manual locate function
You can directly input a time and locate to it.
Touch the Manual Locate button on the Home Screen to open
the MANUAL LOCATE screen.
Touch the FRAME EDIT button to set whether or not the frame
value can be edited.
FRAME EDIT on
FRAME EDIT off
There are three locate modes as follows.
ABS Input an actual time and locate to it.
+
Input an amount of time to go forward from the
current time.
- Input an amount of time to go backward from the
current time.
Input the time using the number buttons.
You can also select a number field in the LOCATE area and use
the DATA dial to adjust the time.
Press the LOCATE button to locate to that new time and return
to the Home Screen.
Touch the CLEAR button to clear all input values.
NOTE
When the CURRENT time display is set to T/C, you can locate
based on the timecode time.
TIP
This can also be edited using an externally connected
keyboard.
Press the keyboard’s Enter key to confirm a setting and its
ESC key to clear all the values.