Teac HS-4000 - Manual (Page 71)

TASCAM HS-4000
71
8 – Take mode
3. Touch the e button for the session that contains the take
you want to load to open the take selection screen.
If it is not the current project, a pop-up window appears
confirming that you want to load it. Touch the OK button.
NOTE
To load a take in the current session, instead of steps 1
to 3, you can do one of the following to move to the take
selection screen of the current session.
• Touch the session name button at the top right of the
project screen.
• Touch the take name button on the Home Screen to
open a pull-down menu and touch the TakeList button.
• Touch the session/take name in the lower information
area of the HOME screen when the INFO button is
pressed.
4. Select the take that you want to load.
5. Touch the MENU button on the take selection screen to
open a pull-up menu.
6. Touch the LOAD button in the pull-up menu.
7. Touch the OK button or press the DATA dial when a confir-
mation pop-up message appears.
After loading completes the Home Screen opens.
NOTE
You can also press the e button for a take to load it.
In this case, no pop-up window appears, and the take
selection screen remains open after loading (the Home
screen does not reopen.)
Setting input monitoring
Turn input monitoring OFF for the channels (tracks) that you are
playing back. Audio from the audio input connectors is output
for the channels that have input monitoring ON.
1. Touch the REC/MON button on the Home Screen to open a
pull-up with REC and MON buttons.
2. If input monitoring is on for any playback channels (MON
buttons appear blue), touch those MON buttons to turn
them off (turning them gray).
Setting the online function
Refer to “Online functions” on page 122 for details about
making settings for the online outputs.
Playback
Press the PLAY key to start playback.
Press the PAUSE key to start playback standby.
To end playback standby, press the PLAY key.
Press the STOP (RETAKE) key to stop playback.
Press the .[MARK.] key or / [MARK /] key to
switch takes.
Press and hold the e [
] key or e [ ] key to search
backward or forward.
While pressing and holding the SHIFT key, press the XXX [MARK.]
key or / [MARK X] key to jump to a mark.
Press and hold the m[
] or ,[ ] key while pressing
and holding the SHIFT key to search at high-speed.
NOTE
On the PLAY SETUP screen, you can set whether only the
currently selected take is played or whether all the takes
within the current session are played. You can also enable
and disable repeat playback. (See “Playback settings (PLAY
SETUP)” on page 103.)
Playback functions can also be used via parallel control.
Call function
Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call point) and
put the unit in playback standby mode.