Teac HS-4000 - Manual (Page 25)

TASCAM HS-4000
25
3 − Preparation
Inserting and removing CF cards
Inserting CF cards
Insert a CF card into CF card SLOT 1 or SLOT 2 on the front panel
of the unit in order to use it for recording and playback.
NOTE
CF cards can be inserted whether the power is ON or OFF.
1. Pull the CF card slot cover forward to open it.
2. Insert the CF card with the correct orientation.
With the labeled side up, insert the end with the connector
completely.
3. Close the cover.
NOTE
If you cannot close the slot cover, remove the CF card once,
press the square button to the right of the slot and then
reinsert the card.
Removing CF cards
Turn the unit power OFF or stop operations before removing a
CF card.
CAUTION
Never remove a CF card during recording, playback or any
other operation that accesses the CF card. Doing so could,
for example, cause recording errors, loss of recorded data,
and sudden loud noises to be output through monitoring
equipment, which could result in damaged equipment and
hearing loss.
1. Pull the CF card slot cover forward to open it.
2. Press the square button to the right of the CF card slot to
bring the button out.
3. Press the square button in again to partially eject the CF
card.
4. Pull the CF card out by hand.