Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 128)

4-12 W A N s u i t e 5 3 7 0
Figure 4.9 Auxiliary Config Screen
Speed Changes the Auxiliary port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 9600
Character Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity Selects the setting for the parity bit if the port is asynchronous.
Values: Five, Six, Seven, Eight
Default: Eight
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Flow Control Selects the type of flow control to be used if the port is asynchronous.
Values: None, Xon/Xoff, RTS/CTS
Default: None
DTR Alarm Control Setting DTR Alarm Control to “Enable” allows the unit to go into alarm on a
loss of DTR.
Values: Disable, Enable
Default: Disable
DTR Alarm Status Indicates the current state of the DTR alarm.
Current Pin Status The Current Pin Status, which shows the state of the RS-232 pins, is displayed
at the bottom of the Auxiliary screen.
10/100 Ethernet (IP Details) Screen
The 10/100 Ethernet (IP Service Details) screen (Figure 4.10) lets you
configure the IP parameters listed below.