Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 151)

V T 1 0 0 I n t e r f a c e 4-35
Backup Endpoint If this DLCI has an alternative endpoint to switch to in case the DLCI
becomes inactive, you would configure the endpoint index of this alternative
endpoint here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
SLP Reference
Endpoint
Use this reference endpoint index for the SLA parameters. As most
applications have the same SLAs for all DLCIs, they only need to be
configured in one DLCI entry. You can then copy all SLA parameters from
the endpoint index of this configured DLCI. If no SLP reference endpoint is
configured and the DLCI SLA parameters are not configured, the values in
the Frame Relay Service Details will be used (default CIR, Be, enforcement).
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
Remote IP Address If this WANsuite 5370 unit is to be used to manage a remote WANsuite 5370
unit, you must configure the IP address of the remote WANsuite 5370 unit
here. This DLCI can be used for management only, or for management and
actual data.
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 5370 can reach a remote WANsuite 5370 through this DLCI. The
remote IP address must be part of an IP network that is different from the
local WANsuite 5370, and the local WANsuite 5370's IP address must be
configured into the PC. This way, local and remote WANsuite 5370s can be
reached regardless of the availability of the routers connected at the back of
the WANsuite 5370s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
The “Delete Endpoint” prompt at the bottom of the screen lets you delete any
endpoint.
Endpoint Service Details Screen
Select from the <Svc> column on the Endpoint Table screen to display the
typical Service Details screen in which you can view, and in some cases