Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 86)

3-56 W A N s u i t e 5 3 7 0
The Static Route Table screen (Figure 3.44) is always associated with a circuit.
Access this menu by selecting the Static Routes Table from the RIP Parameters
Table on the IP Gateway menu.
Figure 3.44 Static Route Table Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Route Status Indicates whether a route is enabled or disabled.
The Static Route Table screen provides the following user-activated buttons:
Route Details Screen
Access this menu (Figure 3.45) by selecting the appropriate numbered link
under the “Index” column on the Static Route screen.
Button Function
Dynamic Route Table Displays routes learned via RIP or OSPF.
Add New Adds a new static route.