Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 159)

V T 1 0 0 I n t e r f a c e 4-43
Tx Alarm Threshold Specifies the threshold in octets for the Transmit Alarm on this rule.
Tx Alarm Shows the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen (Figure 4.38), which can be accessed from
the bottom of the Rule Config screen, displays the number of frames and
octets sent over a DLCI that have been counted in accordance with the
Service Aware “rule” that has been established for a Service. As such, it is
frame relay specific (i.e., DLCIs only occur in frame relay links). In addition,
this screen provides data rate performance information for the period of time
you have specified in the Period Index field (see below).
Figure 4.38 Traffic Meter Statistics Screen
The Traffic Meter Statistics screen reports on the following parameters:
• Tx Frames
• Tx Octets
• Rx Frames
• Rx Octets
• Rate Peak – the peak data rate for the viewed period (see below)
• Rate Average – the average data rate for the viewed period (see below)
The <Period> refers to the period of time for which the Traffic Meter
statistics are reported as listed below.
Summary Represents the past 24 hours; reports the additive number of frames/octets, the
highest peak encountered for 24 hours, and the average for 24 hours.
Current Reports on the current 15-minute interval.
Interval 1,
Interval 2,...,
Interval 96
Reports on Intervals 1-96, which correspond to the periods completed 15
minutes ago, 30 minutes ago,..., 24 hours ago.