Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 69)

W e b S e r v e r I n t e r f a c e 3-39
FrameStart Status If the remote unit is a Verilink unit with FrameStart technology and
FrameStart Auto Discovery is enabled, the FrameStart Status field will show
the status of the remote unit. The status is “Active” if both the local and
remote DLCIs are active and the remote unit answers to the discovery frames
sent by this unit. The status is “SOS” if the remote unit is active but the
FRAD/Router connected to it is inactive. The status is “Inactive” in all other
cases.
Values: Active, Inactive, SOS
Default: Inactive
Remote DLCI If the remote unit is a Verilink unit with FrameStart technology, and
FrameStart Auto Discovery is enabled, this displays the DLCI number used
on the remote end of this DLCI.
Values: 16
−
1023
Default: 0
Remote Unit If the remote unit is a Verilink unit with FrameStart technology, and
FrameStart Auto Discovery is enabled, this parameter gives the first three
digits of the unit ID configured on the remote end of this DLCI.
Values: 000
−
999
Default: 000
Remote Unit IP
Address
Displays the IP address of the remote Verilink unit with FrameStart
technology if FrameStart Auto Discovery is enabled.
Round Trip Delay Size
(bytes)
Specifies the frame size (in bytes) of packets making the round trip. If the
Round Trip Delay Size is not configured, the Frame Relay Details values will
be used.
Round Trip Delay Rate
(secs)
Specifies the rate (in seconds) at which Round Trip Delay packets are sent. If
the Round Trip Delay Rate is not configured, the Frame Relay Details values
will be used.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of and
alarm threshold information for the selected DLCI as follows:
Status If this DLCI is up, the status will be “Active”; otherwise, the status will be
“Inactive.”
Values: Active, Inactive
Default: Inactive
Receiving FECN/
BECN
When a frame is received with a congestion bit set, this parameter is set to
“Yes.” It is set back to “No” when a frame is received without a congestion
bit set.
Values: Yes, No
Default: No