Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 213)

F r o n t P a n e l L C D I n t e r f a c e 5-15
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
Stop Bits Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alrm Setting DTR Alrm to “En” allows the unit to go into alarm on a loss of DTR.
Values: Dis, En
Default: Dis
Diag Msgs Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: En, Dis
Default: En
NOTICE: When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
“Disable.”
Auxiliary Configuration Menu
The AUXILIARY configuration menus let you view and make changes to the
unit’s Auxiliary interface configurations as described below.
Figure 5.14 Auxiliary Configuration Menu Tree
Speed Changes the Auxiliary port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 9600
Ch Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
9600
1200
2400
4800
19200
38400
57600
115200
Speed Ch Size Parity Stop Bits DTR Alrm
8
5
6
7 None
Odd
Even
1
2 Dis
En
Aux
Config