Verilink WANsuite 5370 (34-00310.D) Product Manual - Manual (Page 133)

V T 1 0 0 I n t e r f a c e 4-17
Figure 4.15 Data Line Monitor Config Table
Service Enable and
Disable
Displays whether capture is Enabled or Disabled.
Tx/Rx Filter Displays the direction of the captured data.
Pattern Filter Enable Displays the Filter for the pattern being searched and captured.
Pattern Displays which specific pattern is being searched for.
Mask Displays the bits the unit is looking for.
Offset Displays the offset in the packet that matches the pattern.
You may view the captured data in the Packet Capture screen (Figure 4.16)
by selecting the prompt at the top of the Data Line Monitor screen. The
screen shows about 10 lines of active data, and if a line is selected, the screen
will display further decoded data below.