Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 131)

W e b S e r v e r I n t e r f a c e 3-99
Configuration.” The WANsuite unit will reset, after which it will use the
uploaded configuration.
To install software, click on the “Browse” button to select the file you want
installed. Then click on “HTTP Software Install.”
NOTICE: Make sure you allow sufficient time for the installation to occur.
Canceling the installation before it has fully executed will result in the
new software NOT being installed into the unit.
Figure 3.99 Upload/Save Screen
TFTP Configuration
A Trivial File Transfer Protocol (TFTP) service on a server can provide
remote file access to the WANsuite 7105 to
• Update the firmware on a WANsuite unit
• Save the configuration setup of a WANsuite unit
• Restore a saved configuration setup to a WANsuite unit
To transfer a file to or from a TFTP server from a WANsuite unit, you must
indicate the TFTP server’s IP address, the file name, and then perform a Get
operation to receive a file from the server, or a Put operation to send a file to
the server. The file name and its extension determine the type of file
transferred.
The table below shows the possible file operations.
Operation Filename Extension Action
Update Application Firmware .CHX or .HEX(1) Get
Update Boot Firmware .HEX(2) Get