Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 132)

3-100 W A N s u i t e 7 1 0 5
Note that when updating the application software using a .HEX file, the
filename should have the form xxAPxxxx.HEX; the AP indicates the file is
an application load. When updating the boot software, the filename should
have the form
xxWBxxxx.HEX ; the WB indicates the file is a boot load.
Password
The Password screen (Figure 3.100) is used to modify the password that
restricts access to the Web Server interface.
Acceptable characters for use in a password are digits 0–9 and letters A–Z
and a–z, for a total of 62 distinct characters.
Figure 3.100 Password Screen
To change either the Admin or Read-Only password, you must enter it once
in the New Password field and then re-enter the same password in the
Confirm Password field. After entering the new password in both these fields,
click the “Change Admin Password” or the “Change Read Only Password”
button to update and establish the new password.
NOTICE: Remember that passwords are case-sensitive and are limited to no more
than 10 characters. When logging on, password must be entered exactly
as it was programmed.
Log Out
The Log Out screen (Figure 3.101) is used to log the current user off of the
Web server. The Log Out function is only available after user password
protection has been set. You will be automatically logged out of the system
1 hour after you log on using a password to gain access; after this, you will be
required to enter the password to gain write access.
Save Configuration Setup .CFG Put
Restore Configuration Setup .CFG Get
Operation Filename Extension Action