Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 86)

3-54 W A N s u i t e 7 1 0 5
NOTICE: To use this filter, you must specify both the Service and DLCI
parameters on the Rule Details screen.
IP Address Establishes the IP address by which the rule will filter IP traffic (if enabled).
IP Mask Represents a range of IP addresses defined so that only machines with IP
addresses within that range are allowed to access an Internet service. To mask
a portion of the IP address, replace it with the wild card character “0” (zero).
(For example, 192.44.0.0 represents every computer on the Internet with an IP
address beginning with 192.44.)
Filter By IP Address Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
IP Port Establishes the IP port by which the rule will filter IP traffic (if enabled).
Filter By IP Port Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field. You may enter the port value directly into this field or select a port
ID from the drop-down list to the right of the field (see next paragraph).
Tx Alarm Threshold Specifies the threshold in bits per second for the Transmit Alarm on this rule.
Tx Alarm Shows the current Transmit Alarm status.
IP Port List Provides a drop-down list of well-known port IDs for TCP and UDP. To enter
a port ID, select an option from the list and click the “Enter” button. The
selected port ID value will then be reflected in the IP Port field.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen (Figure 3.47) displays the number of
frames and octets sent over a DLCI that have been counted in accordance
with the Service Aware “rule” established for a Service. As such, it is Frame
Relay specific (i.e., DLCIs only occur in Frame Relay links). In addition, this
screen provides data rate performance information for the period of time
specified in the Period Index field (see below). To access this screen, click on
the appropriate link under the “Statistics” column on the Service Aware
screen.