Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 139)

V T 1 0 0 I n t e r f a c e 4-5
The System screen displays the user-selectable prompts listed below.
Maintenance Reset
Select this prompt to access a screen (Figure 4.3) where you can reset your
unit to factory defaults.
Figure 4.3 Maintenance Reset Screen
Using the space bar, you may toggle through the options to select the desired
maintenance reset (Default TDM Configuration, Default Packet Configuration,
Default Packet 3 Configuration, or Default Packet 4 Configuration). After you
select an option, the unit will display a confirmation screen (Figure 4.3) where
you may choose either to proceed with the maintenance reset or not.
NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit. Refresh (by pressing
“Ctrl+U”) after approximately 10 seconds to restore communications.
Prompt Function
Maintenance Reset Brings up a screen where you can reset unit to its default
TDM or Packet, Packet 3, or Packet 4 configuration.
Save and Restart Saves the current configuration and restarts the unit.