Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 180)

4-46 W A N s u i t e 7 1 0 5
Figure 4.38 DLCI Details Screen
The unit uses the first three configuration parameters (Protocol Encapsulation,
Proprietary Traffic Type, and Proprietary Offset) to gather statistics. For in-
band management, “RFC 1490” must be the encapsulation method.
Protocol Encapsulation This is the type of encapsulation used by the FRAD/router connected to the
unit.
Values: RFC 1490, Proprietary, RFC1490-Encrypt
Default: RFC 1490
Proprietary Traffic
Type
When Protocol Encapsulation is set for “Proprietary,” the Proprietary Traffic
Type parameter defines which protocol is encapsulated.
Values: IP, IPX, Ethertype, None
Default: None
Proprietary Offset When Protocol Encapsulation is set for “Proprietary,” the Proprietary Offset
parameter defines the number of octets after the frame relay header where the
proprietary traffic type starts.
Values: 0–64
Default: 0
CIR (bps) If a Committed Information Rate is configured here, its value will be used
instead of the default CIR of the frame relay service.
Values: 0–1536000
Default: 0
Be (bps) If an Excess Burst Rate is configured here, its value will be used instead of
the default excess burst of the frame relay service.
Values: 0–1536000
Default: 0