Configuring ospfv3 ipsec policies, Network requirements, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 353
337
# Display the BFD information of Switch A.
<SwitchA> display bfd session
The output shows that Switch A has deleted the BFD session on VLAN-interface 10 to Switch B and
displays no output.
# Display routes destined for 2001:4/64 on Switch A.
<SwitchA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 1
Destination : 2001:4:: PrefixLength : 64
NextHop : 2001:2::2 Preference : 10
IpPrecedence : QosLcId :
RelayNextHop : :: Tag : 0H
Neighbor : :: ProcessID : 0
Interface : Vlan-interface11 Protocol : OSPFv3
State : Active Adv Cost : 2
Tunnel ID : 0x0 Label : NULL
Age : 4610sec
The output shows that Switch A communicates with Switch B through VLAN-interface 11.
Configuring OSPFv3 IPsec policies
Network requirements
As shown in
, configure OSPFv3 on the switches. The AS is divided into two areas. Configure
IPsec policies on the switches to authenticate and encrypt protocol packets.
Figure 113 Network diagram
Configuration procedure
1.
Configure IPv6 addresses for interfaces. (Details not shown.)
2.
Configure basic OSPFv3:
# Configure Switch A, enable OSPFv3, and configure the router ID as 1.1.1.1.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3 1