H3C Technologies H3C S12500 Series Switches User Manual
Page 415
399
# Apply policy aaa to Switch A.
[SwitchA] ipv6 local policy-based-route aaa
# Configure the IPv6 addresses of the VLAN interfaces.
[SwitchA] interface Vlan-interface 10
[SwitchA-Vlan-interface10] ipv6 address 1::1 64
[SwitchA-Vlan-interface10] quit
[SwitchA] interface Vlan-interface 20
[SwitchA-Vlan-interface20] ipv6 address 2::1 64
2.
Configure the IPv6 address for VLAN-interface 10 on Switch B.
<SwitchB> system-view
[SwitchB] interface Vlan-interface 10
[SwitchB-Vlan-interface10] ipv6 address 1::2 64
[SwitchB-Vlan-interface10] quit
3.
Configure the IPv6 address for VLAN-interface 20 on Switch C.
<SwitchC> system-view
[SwitchC] interface Vlan-interface 20
[SwitchC-Vlan-interface20] ipv6 address 2::2 64
[SwitchC-Vlan-interface20] quit
4.
Verify the configuration:
# Telnet to Switch B (1::2/64) from Switch A. The operation succeeds.
<SwitchA> telnet ipv6 1::2
Trying 1::2 ...
Press CTRL+K to abort
Connected to 1::2 ...
******************************************************************************
* Copyright (c) 2004-2011 Hangzhou H3C Tech. Co., Ltd. All rights reserved. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
# Telnet to Switch C (2::2/64) from Switch A. The operation fails.
<SwitchA> telnet ipv6 2::2
Trying 2::2 ...
Press CTRL+K to abort
Can't connect to the remote host!
# Ping Switch C (2::2/64) from Switch A. The operation succeeds.
<SwitchA> ping ipv6 2::2
PING 2::2 : 56 data bytes, press CTRL_C to break
Reply from 2::2
bytes=56 Sequence=1 hop limit=64 time = 4 ms
Reply from 2::2
bytes=56 Sequence=2 hop limit=64 time = 2 ms
Reply from 2::2
bytes=56 Sequence=3 hop limit=64 time = 2 ms
Reply from 2::2
bytes=56 Sequence=4 hop limit=64 time = 2 ms
Reply from 2::2
bytes=56 Sequence=5 hop limit=64 time = 2 ms