H3C Technologies H3C S5560 Series Switches - Manual (Page 217)

201
Tasks at a glance Remarks
(Optional.) Controlling BGP path selection :
• Specifying a preferred value for routes received
• Configuring preferences for BGP routes
• Configuring the default local preference
• Configuring the MED attribute
• Configuring the NEXT_HOP attribute
• Configuring the AS_PATH attribute
N/A
(Optional.) Tuning and optimizing BGP networks :
• Configuring the keepalive interval and hold time
• Configuring the interval for sending updates for the same route
• Enabling BGP to establish an EBGP session over multiple hops
• Enabling immediate re-establishment of direct EBGP connections upon link failure
• Enabling 4-byte AS number suppression
• Enabling MD5 authentication for BGP peers
• Configuring BGP load balancing
• Configuring IPsec for IPv6 BGP
• Disabling BGP to establish a session to a peer or peer group
• Configuring GTSM for BGP
• Configuring BGP soft-reset
• Protecting an EBGP peer when memory usage reaches level 2 threshold
N/A
(Optional.) Configuring a large-scale BGP network :
• Configuring BGP community
• Configuring BGP route reflection
• Ignoring the ORIGINATOR_ID attribute
• Configuring a BGP confederation
N/A
(Optional.) Configuring BGP GR N/A
(Optional.) Configuring BGP NSR
(Optional.) Enabling SNMP notifications for BGP N/A
(Optional.) Enabling logging of session state changes N/A
(Optional.) Configuring BFD for BGP N/A
(Optional.) Configuring BGP FRR N/A
To configure BGP, perform the following tasks (IPv6):
Tasks at a glance Remarks
Configuring basic BGP :
• (Required.) Enabling BGP
• (Required.) Perform one of the following tasks:
{
Configuring a BGP peer
{
Configuring dynamic BGP peers
{
Configuring a BGP peer group
• (Optional.) Specifying the source interface for TCP connections
H3C recommends that
you configure BGP peer
groups on large scale
BGP networks for easy
configuration and
maintenance.