Verifying the configuration – H3C Technologies H3C S5560 Series Switches User Manual

Page 36

Advertising
background image

20

[SwitchB] ip route-static 121.1.1.0 24 1.1.1.9 bfd control-packet bfd-source 2.2.2.9

[SwitchB] ip route-static 121.1.1.0 24 vlan-interface 13 13.1.1.2 preference 65

[SwitchB] quit

# Configure static routes on Switch C.

<SwitchC> system-view

[SwitchC] ip route-static 120.1.1.0 24 13.1.1.1

[SwitchC] ip route-static 121.1.1.0 24 10.1.1.102

# Configure static routes on Switch D.

<SwitchD> system-view

[SwitchD] ip route-static 120.1.1.0 24 11.1.1.1

[SwitchD] ip route-static 121.1.1.0 24 12.1.1.1

Verifying the configuration

# Display BFD sessions on Switch A.

<SwitchA> display bfd session

Total Session Num: 1 Up Session Num: 1 Init Mode: Active

IPv4 Session Working Under Ctrl Mode:

LD/RD SourceAddr DestAddr State Holdtime Interface

4/7 1.1.1.9 2.2.2.9 Up 2000ms N/A

The output shows that the BFD session has been created.
# Display the static routes on Switch A.

<SwitchA> display ip routing-table protocol static

Summary Count : 1

Static Routing table Status : <Active>

Summary Count : 1

Destination/Mask Proto Pre Cost NextHop Interface

120.1.1.0/24 Static 60 0 12.1.1.2 Vlan10

Static Routing table Status : <Inactive>

Summary Count : 0

The output shows that Switch A communicates with Switch B through VLAN-interface 10. Then the link
over VLAN-interface 10 fails.
# Display static routes on Switch A.

<SwitchA> display ip routing-table protocol static

Summary Count : 1

Static Routing table Status : <Active>

Summary Count : 1

Destination/Mask Proto Pre Cost NextHop Interface

Advertising
This manual is related to the following products: