Network requirements – H3C Technologies H3C S5560 Series Switches User Manual
Page 72
56
TableID: 0x2 OrigAs: 0
NibID: 0x12000002 LastAs: 0
AttrID: 0xffffffff Neighbor: 192.168.2.1
Flags: 0x1008c OrigNextHop: 192.168.2.1
Label: NULL RealNextHop: 192.168.2.1
BkLabel: NULL BkNextHop: N/A
Tunnel ID: Invalid Interface: vlan-interface 100
BkTunnel ID: Invalid BkInterface: N/A
# Display routes destined for 100.1.1.0/24 on Switch B when the link between Switch A and
Switch B fails.
<SwitchB> display ip routing-table 100.1.1.0 24 verbose
Summary Count : 1
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 1
SubProtID: 0x1 Age: 00h21m23s
Cost: 4 Preference: 100
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0x2 OrigAs: 0
NibID: 0x12000002 LastAs: 0
AttrID: 0xffffffff Neighbor: 192.168.3.2
Flags: 0x1008c OrigNextHop: 192.168.3.2
Label: NULL RealNextHop: 192.168.3.2
BkLabel: NULL BkNextHop: N/A
Tunnel ID: Invalid Interface: vlan-interface 200
BkTunnel ID: Invalid BkInterface: N/A
BFD for RIP configuration example (bidirectional detection in
BFD control packet mode)
Network requirements
As shown in
, VLAN-interface 100 of Switch A and VLAN-interface 200 of Switch C run RIP
process 1.
VLAN-interface 300 of Switch A runs RIP process 2. VLAN-interface 400 of Switch C, and
VLAN-interface 300 and VLAN-interface 400 of Switch D run RIP process 1.
•
Configure a static route destined for 100.1.1.0/24 on Switch A.
•
Configure a static route destined for 101.1.1.0/24 on Switch C.
•
Enable static route redistribution into RIP on Switch A and Switch C. This allows Switch A to learn
two routes destined for 100.1.1.0/24 through VLAN-interface 100 and VLAN-interface 300. It uses
the route through VLAN-interface 100.
•
Enable BFD on VLAN-interface 100 of Switch A and VLAN-interface 200 of Switch C.
When the link over VLAN-interface 100 fails, BFD can quickly detect the link failure and notify RIP. RIP
deletes the neighbor relationship and the route information received learned on VLAN-interface 100. It
uses the route destined for 100.1.1.0/24 through VLAN-interface 300.