Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual

Page 459

Advertising
background image

443

Figure 102 Network diagram

Configuration procedure

1.

Configure Switch A:
# Configure IPv6 addresses for VLAN-interface 100 and VLAN-interface 200.

<SwitchA> system-view

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ipv6 address 10::1 32

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 200

[SwitchA-Vlan-interface200] ipv6 address 11::1 32

[SwitchA-Vlan-interface200] quit

# Enable RIPng on VLAN-interface 100.

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ripng 1 enable

[SwitchA-Vlan-interface100] quit

# Configure three static routes with next hop 11::2, and make sure the static routes are active.

[SwitchA] ipv6 route-static 20:: 32 11::2

[SwitchA] ipv6 route-static 30:: 32 11::2

[SwitchA] ipv6 route-static 40:: 32 11::2

# Configure a routing policy.

[SwitchA] ipv6 prefix-list a index 10 permit 30:: 32

[SwitchA] route-policy static2ripng deny node 0

[SwitchA-route-policy-static2ripng-0] if-match ipv6 address prefix-list a

[SwitchA-route-policy-static2ripng-0] quit

[SwitchA] route-policy static2ripng permit node 10

[SwitchA-route-policy-static2ripng-10] quit

# Enable RIPng and apply the routing policy to static route redistribution.

[SwitchA] ripng

[SwitchA-ripng-1] import-route static route-policy static2ripng

2.

Configure Switch B:
# Configure the IPv6 address for VLAN-interface 100.

<SwitchB> system-view

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ipv6 address 10::2 32

# Enable RIPng.

[SwitchB] ripng

[SwitchB-ripng-1] quit

# Enable RIPng on VLAN-interface 100.

Advertising
This manual is related to the following products: