Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual

Page 357

Advertising
background image

341

Figure 83 Network diagram

Table 19 Interface and IP address assignment

Device Interface

IPv6 address

Switch A

Vlan-int10

12::1/64

Switch A

Vlan-int11

10::102/64

Switch B

Vlan-int10

12::2/64

Switch B

Vlan-int13

13::1/64

Switch C

Vlan-int11

10::100/64

Switch C

Vlan-int13

13::2/64

Configuration procedure

1.

Configure IPv6 addresses for interfaces. (Details not shown.)

2.

Configure IPv6 static routes and BFD:
# Configure IPv6 static routes on Switch A and enable BFD control mode for the static route that

traverses the Layer 2 switch.

<SwitchA> system-view

[SwitchA] interface vlan-interface 10

[SwitchA-vlan-interface10] bfd min-transmit-interval 500

[SwitchA-vlan-interface10] bfd min-receive-interval 500

[SwitchA-vlan-interface10] bfd detect-multiplier 9

[SwitchA-vlan-interface10] quit

[SwitchA] ipv6 route-static 120:: 64 vlan-interface 10 FE80::2E0:FCFF:FE58:123E bfd

control-packet

[SwitchA] ipv6 route-static 120:: 64 10::100 preference 65

[SwitchA] quit

# Configure IPv6 static routes on Switch B and enable BFD control mode for the static route that
traverses the Layer 2 switch.

<SwitchB> system-view

[SwitchB] interface vlan-interface 10

[SwitchB-vlan-interface10] bfd min-transmit-interval 500

[SwitchB-vlan-interface10] bfd min-receive-interval 500

[SwitchB-vlan-interface10] bfd detect-multiplier 9

[SwitchB-vlan-interface10] quit

[SwitchB] ipv6 route-static 121:: 64 vlan-interface 10 FE80::2A0:FCFF:FE00:580A bfd

control-packet

Advertising
This manual is related to the following products: