Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual

Page 374

Advertising
background image

358

Figure 86 Network diagram

Configuration procedure

1.

Configure IPv6 addresses for interfaces. (Details not shown.)

2.

Configure basic RIPng:
# Enable RIPng 100 on Switch A.

<SwitchA> system-view

[SwitchA] ripng 100

[SwitchA-ripng-100] quit

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ripng 100 enable

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 200

[SwitchA-Vlan-interface200] ripng 100 enable

[SwitchA-Vlan-interface200] quit

# Enable RIPng 100 and RIPng 200 on Switch B.

<SwitchB> system-view

[SwitchB] ripng 100

[SwitchB-ripng-100] quit

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ripng 100 enable

[SwitchB-Vlan-interface100] quit

[SwitchB] ripng 200

[SwitchB-ripng-200] quit

[SwitchB] interface vlan-interface 300

[SwitchB-Vlan-interface300] ripng 200 enable

[SwitchB-Vlan-interface300] quit

# Enable RIPng 200 on Switch C.

<SwitchC> system-view

[SwitchC] ripng 200

[SwitchC] interface vlan-interface 300

[SwitchC-Vlan-interface300] ripng 200 enable

[SwitchC-Vlan-interface300] quit

[SwitchC] interface vlan-interface 400

[SwitchC-Vlan-interface400] ripng 200 enable

[SwitchC-Vlan-interface400] quit

# Display the routing table on Switch A.

[SwitchA] display ipv6 routing-table

Destinations : 7 Routes : 7

Advertising
This manual is related to the following products: