Configuring received/redistributed route filtering, Configuring a preference for rip – H3C Technologies H3C S5560 Series Switches User Manual

Page 48

Advertising
background image

32

Step Command

Remarks

3.

Enable RIP to advertise a
default route.

default-route { only | originate }
[ cost cost ]

By default, RIP does not advertise a
default route.

4.

Return to system view.

quit

N/A

5.

Enter interface view.

interface interface-type
interface-number

N/A

6.

Configure the RIP interface to

advertise a default route.

rip default-route { { only |
originate } [ cost cost ] |
no-originate }

By default, a RIP interface can
advertise a default route if the RIP

process is enabled to advertise a

default route.

NOTE:

The router enabled to advertise a default route does not accept default routes from RIP neighbors.

Configuring received/redistributed route filtering

Perform this task to filter received and redistributed routes by using a filtering policy.
To configure route filtering:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter RIP view.

rip [ process-id ] [ vpn-instance
vpn-instance-name ]

N/A

3.

Configure the filtering of

received routes.

filter-policy { acl-number | gateway
prefix-list-name | prefix-list

prefix-list-name [ gateway
prefix-list-name ] } import

[ interface-type interface-number ]

By default, the filtering of
received routes is not configured.
This command filters received

routes. Filtered routes are not
installed into the routing table or

advertised to neighbors.

4.

Configure the filtering of
redistributed routes.

filter-policy { acl-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] | interface-type

interface-number ]

By default, the filtering of
redistributed routes is not

configured.
This command filters redistributed
routes, including routes

redistributed with the

import-route command.

Configuring a preference for RIP

If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest priority

is selected as the optimal route. Perform this task to assign a preference to RIP. The smaller the preference

value, the higher the priority.
To configure a preference for RIP:

Advertising
This manual is related to the following products: