H3C Technologies H3C S5560 Series Switches - Manual (Page 87)

71
Tasks at a glance
(Optional.) Tuning and optimizing OSPF networks :
• Configuring OSPF timers
• Specifying LSA transmission delay
• Specifying SPF calculation interval
• Specifying the LSA arrival interval
• Specifying the LSA generation interval
• Disabling interfaces from receiving and sending OSPF packets
• Configuring stub routers
• Configuring OSPF authentication
• Adding the interface MTU into DD packets
• Configuring a DSCP value for OSPF packets
• Configuring the maximum number of external LSAs in LSDB
• Configuring OSPF exit overflow interval
• Enabling compatibility with RFC 1583
• Logging neighbor state changes
• Configuring OSPF network management
• Configuring the LSU transmit rate
• Enabling OSPF ISPF
• Configuring prefix suppression
• Configuring prefix prioritization
• Configuring OSPF PIC
• Configuring the number of OSPF logs
(Optional.) Configuring OSPF GR
• Configuring OSPF GR restarter
• Configuring OSPF GR helper
• Triggering OSPF GR
(Optional.) Configuring OSPF NSR
(Optional.) Configuring BFD for OSPF
(Optional.) Configuring OSPF FRR
Enabling OSPF
Enable OSPF before you perform other OSPF configuration tasks.
Configuration prerequisites
Configure the link layer protocol and IP addresses for interfaces to ensure IP connectivity between
neighboring nodes.
Configuration guidelines
To enable OSPF on an interface, you can enable OSPF on the network where the interface resides or
directly enable OSPF on that interface. If you configure both, the latter takes precedence.