HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 26)

26
13.1 General Information about Touch Probe Cycles ..... 278
Method of function ..... 278
Consider a basic rotation in the Manual Operation mode ..... 278
Cycles in the Manual and El. Handwheel Modes ..... 278
Touch probe cycles for automatic operation ..... 279
13.2 Before You Start Working with Touch Probe Cycles ..... 281
Maximum traverse to touch point: DIST in touch probe table ..... 281
Setup clearance to touch point: SET_UP in touch probe table ..... 281
Orient the infrared touch probe to the programmed probe direction: TRACK in touch probe table ..... 281
Touch trigger probe, probing feed rate: F in touch probe table ..... 282
Touch trigger probe, rapid traverse for positioning: FMAX ..... 282
Touch trigger probe, rapid traverse for positioning: F_PREPOS in touch probe table ..... 282
Multiple measurements ..... 282
Confidence range for multiple measurement ..... 282
Executing touch probe cycles ..... 283
13.3 Touch Probe Table ..... 284
General information ..... 284
Editing touch probe tables ..... 284
Touch probe data ..... 285
13 Using Touch Probe Cycles ..... 277