Calling cycles, 1 w o rk ing with fix e d cy cles – HEIDENHAIN TNC 320 (340 55x-04) Cycle programming User Manual
Page 42
42
Using Fixed Cycles
2.1 W
o
rk
ing with Fix
e
d Cy
cles
Calling cycles
The following cycles become effective automatically as soon as they
are defined in the part program. These cycles cannot and must not be
called:
Cycle 220 for point patterns on circles and Cycle 221 for point
patterns on lines
SL Cycle 14 CONTOUR GEOMETRY
SL Cycle 20 CONTOUR DATA
Cycle 32 TOLERANCE
Coordinate transformation cycles
Cycle 9 DWELL TIME
All touch probe cycles
You can call all other cycles with the functions described as follows.
Prerequisites
The following data must always be programmed before a
cycle call:
BLK FORM
for graphic display (needed only for test
graphics)
Tool call
Direction of spindle rotation (M functions M3/M4)
Cycle definition (CYCL DEF)
For some cycles, additional prerequisites must be
observed. They are detailed in the descriptions for each
cycle.