HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 310)

310 Touch Probe Cycles: Automatic Datum Setting
15.1 F
undamentals
15.1 Fundamentals
Overview
The TNC offers twelve cycles for automatically finding reference
points and handling them as follows:
„ Setting the determined values directly as display values
„ Entering the determined values in the preset table
„ Entering the determined values in a datum table
Danger of collision!
When running touch probe cycles, no cycles must be
active for coordinate transformation (Cycle 7 DATUM,
Cycle 8 MIRROR IMAGE, Cycle 10 ROTATION, Cycles 11
and 26 SCALING and Cycle 19 WORKING PLANE or 3D-
ROT).
The TNC must be specially prepared by the machine tool
builder for the use of a 3-D touch probe.
Cycle Soft key Page
408 SLOT CENTER REF PT. Measuring
the inside width of a slot, and defining
the slot center as datum Page 313
409 RIDGE CENTER REF PT. Measuring
the outside width of a ridge, and defining
the ridge center as datum Page 317
410 DATUM INSIDE RECTAN.
Measuring the inside length and width of
a rectangle, and defining the center as
datum Page 320
411 DATUM OUTSIDE RECTAN.
Measuring the outside length and width
of a rectangle, and defining the center as
datum Page 324
412 DATUM INSIDE CIRCLE Measuring
any four points on the inside of a circle,
and defining the center as datum Page 328
413 DATUM OUTSIDE CIRCLE
Measuring any four points on the
outside of a circle, and defining the
center as datum Page 332