HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 284)

284 Using Touch Probe Cycles
13.3 T
ouc
h Pr
obe T
a
ble
13.3 Touch Probe Table
General information
Various data is stored in the touch probe table that defines behavior
with the probe process. If you run several touch probes on your
machine tool, you can save separate data for each touch probe.
Editing touch probe tables
To edit the touch probe table, proceed as follows:
U Select the Manual Operation mode.
U Select the touch probe functions by pressing the
PROBE FUNCTION soft key. The TNC displays
additional soft keys: see table above.
U Select the touch probe table: Press the TOUCH
PROBE TABLE soft key.
U Set the EDIT soft key to ON.
U Using the arrow keys, select the desired setting.
U Perform desired changes.
U Exit the touch probe table: Press the END soft key.