HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 419)

HEIDENHAIN TNC 320 419
1
8
.1 F
undamentals
Differences between Cycles 31 to 33 and
Cycles 481 to 483
The features and the operating sequences are absolutely identical.
There are only two differences between Cycles 31 to 33 and
Cycles 481 to 483:
„ Cycles 481 to 483 are also available in controls for ISO programming
under G481 to G483.
„ Instead of a selectable parameter for the status of the
measurement, the new cycles use the fixed parameter Q199.