Recording the results of measurement, 1 f undamentals – HEIDENHAIN TNC 320 (340 55x-04) Cycle programming User Manual
Page 365
HEIDENHAIN TNC 320
365
16.1 F
undamentals
Recording the results of measurement
For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record the
measurement results. In the respective probing cycle you can define
if the TNC is to
Save the measuring log to a file.
Interrupt the program run and display the measuring log on the
screen.
Create no measuring log.
If you want to save the measuring log to a file, the TNC, by default,
saves the data as an ASCII file in the directory TNC:\..
430 MEAS. BOLT HOLE CIRC. (2nd soft-
key level) Measuring position and
diameter of a bolt hole circle
431 MEASURE PLANE (2nd soft-key
level) Measuring the A and B axis angles
of a plane
Cycle
Soft key
Page
Use the HEIDENHAIN data transfer software TNCremo if
you wish to output the measuring log via the data
interface.