HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 299)

HEIDENHAIN TNC 320 299
14.5 BA
SIC R
O
T
A
TION compensation via r
o
tary axis (Cy
c
le 403,
DIN/ISO:
G403)
14.5 BASIC ROTATION
compensation via rotary axis
(Cycle 403, DIN/ISO: G403)
Cycle run
Touch Probe Cycle 403 determines a workpiece misalignment by
measuring two points, which must lie on a straight surface. The TNC
compensates the determined misalignment by rotating the A, B or C
axis. The workpiece can be clamped in any position on the rotary table.
1 The TNC positions the touch probe at rapid traverse (value from
FMAX column) following the positioning logic (see “Executing
touch probe cycles” on page 283) to the programmed starting
point
1 . The TNC offsets the touch probe by the safety clearance
in the direction opposite the defined traverse direction.
2 Then the touch probe moves to the entered measuring height and
probes the first touch point at the probing feed rate (column F).
3 Then the touch probe moves to the next starting position 2 and
probes the second position.
4 The TNC returns the touch probe to the clearance height and
moves the rotary axis, which was defined in the cycle, by the
measured value. Optionally you can have the display set to 0 after
alignment.
Please note while programming:
X
Y
1
2
Danger of collision!
The TNC does not check whether touch points and
compensation axis match. This can result in compensation
movements offset by 180°.
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
The TNC stores the measured angle in parameter Q150.