HEIDENHAIN TNC 320 (340 55x-04) Cycle programming - Manual (Page 37)

HEIDENHAIN TNC 320 37
1
.2 A
v
ailable Cy
cle Gr
oups
1.2 Available Cycle Groups
Overview of fixed cycles
U The soft-key row shows the available groups of
cycles.
U If required, switch to machine-specific fixed cycles.
These fixed cycles can be integrated by your machine
tool builder.
Cycle group Soft key Page
Cycles for pecking, reaming, boring, and counterboring Page 58
Cycles for tapping, thread cutting and thread milling Page 92
Cycles for milling pockets, studs and slots Page 126
Cycles for producing point patterns, such as circular or linear hole patterns Page 158
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively complex
contours consisting of several overlapping subcontours, cylinder surface interpolation Page 170
Cycles for multipass milling of flat or twisted surfaces Page 226
Coordinate transformation cycles which enable datum shift, rotation, mirror image, enlarging and
reducing for various contours Page 242
Special cycles such as dwell time, program call, oriented spindle stop and tolerance Page 268